Small rotary drilling rigs are now a great helper for our modern foundation piling, allowing us to quickly advance on the road to wealth. To ensure the safe operation of your small rotary drilling rig, the SDLQ rotary drilling rig editor reminds you to read this article carefully to understand what precautions should be taken when transporting a small rotary drilling rig.#hydraulic rotary rig#
1. When transporting a drilling rig on public roads, comply with local transportation regulations.
2. Use a truck or specialized vehicle suitable for transporting the drilling rig.
3. In addition to using a hoist or loading platform, the rotary drilling rig can also be loaded onto a transport vehicle using two sufficiently strong slats.
The slats should not be made of smooth steel; it is best to use non-slip materials such as rubber sheets. The slat width should be 1.2 to 1.5 times the width of the tracks or tires.#hydraulic rotary rig#
4. Refer to the instruction manual for instructions on loading onto the transport vehicle.
5. When moving up or down the chute, do not operate any handles other than those for operating the travel mechanism.
6. Loading and unloading should be performed on solid ground.
The SDLQ rotary drilling rig editor offers a few final operating precautions:
1. After starting the engine, run it at low speed for 3-5 minutes and operate the power unit under no load to ensure proper operation of the hydraulic system.
2. While the drilling rig is operating, the operator should frequently check the various instruments for proper function. If any abnormality is detected, the rig should be stopped and inspected immediately. 3. During operation, pay special attention to ensuring that the control handle is in place to avoid pressure shocks in the system.
4. During operation, check and tighten the pipe joints and oil pump bolts that may cause pressure shock to ensure there are no oil or air leaks.
5. The drilling rig must be operated by a dedicated person, and special attention must be paid to hazardous areas such as high-voltage wires and puddles.
6. Standing within the drilling rig's slewing range is strictly prohibited.
7. After the drilling rig is moved, the crawler tracks must be extended immediately after it is unloaded from the flatbed.
8. When checking the hydraulic oil, wait until the oil has cooled before proceeding.
9. When welding drill rod components, always turn off the power switch.
10. Regularly inspect the slewing joint.
The SDLQ rotary drilling rig editor reminds you to be familiar with and understand the above-mentioned transportation and operation precautions for small rotary drilling rigs. We recommend saving this information for future reference. If you have any questions, please leave a comment below. #hydraulic rotary rig#
